Side plates

Show us your design ideas and concept images.
Post Reply
bert0851
Posts: 1
Joined: Thu Jul 13, 2017 6:26 pm

Side plates

Post by bert0851 » Fri May 11, 2018 4:59 pm

The side plates are to short for my 2 horse wearing house motor and am going to have to grind out some welds to remove them and cut and add an inch to get clearance for turning vertical. That is all thank you for the plans they are great at her than that one issue

User avatar
admin
Site Admin
Posts: 124
Joined: Wed Jul 05, 2017 8:03 am

Re: Side plates

Post by admin » Sun May 13, 2018 4:48 pm

Hi Bert,

Can you explain better? Does the motor not go through the holes or is the motor too long to rotate from horizontal to vertical?

Thanks,

Dan

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests