Simko's Weld Together OSG

Show us your grinder!
Posts: 3
Joined: Sat Oct 13, 2018 10:22 pm

Re: Simko's Weld Together OSG

Post by jeep.eater » Thu Feb 07, 2019 9:20 pm

Hey there Simko I was wondering if you had some measurements for the shims you used behind the wheels just looking to get close without too much back and forth putting it together and taking it apart a bunch of times and getting angry I'm ready for final assembly here after paint and wanna save myself some headache

Posts: 17
Joined: Wed Jan 17, 2018 2:03 pm

Re: Simko's Weld Together OSG

Post by Simko » Fri Feb 08, 2019 10:22 am

After doing three grinders, I can say that each one was slightly different.

I would get an assortment of 1/2” ID shims (0.060, 0.030, 0.015, 0.010) and start with all of the wheels with just a 0.060” shim between the wheel and the plate and enough shims to make up the extra space on the outside of the shoulder bolt. I didn’t get too technical with the make up shims because the wheel pretty much stayed in place while testing. Once I got it pretty close then I added shims to the outside to take up all of the slop. If you need to shim the inside anymore, just move shims from outside the wheel to inside (between the wheel and platen plate).

It didn’t really take too long to do each one (30-45 mins) and that was really taking my time.

Put on a low grit belt and run the grinder slow so that you can try to stop it before it runs into anything.

Start with the platen wheels and get the belt running centered on those two wheels. After that is centered, look at the tracking wheel to see how much it needs to come out for the belt to be centered on it.

The tracking wheel for whatever reason needed about .120” to get the belt to run centered on it while it was centered on the platen wheels. Doesn’t make sense because it is on the same plane as the other wheels?!?

Sorry I can’t give you any better info. Each grinder is going to be different.

Posts: 3
Joined: Sat Oct 13, 2018 10:22 pm

Re: Simko's Weld Together OSG

Post by jeep.eater » Sun Feb 10, 2019 9:46 am

Thanks a bunch that will get me rolling

Posts: 1
Joined: Wed Mar 27, 2019 7:20 pm

Re: Simko's Weld Together OSG

Post by sxt15 » Mon Apr 01, 2019 2:46 pm

Hey im about to have 4 of the Rev 4 plans cut out. Was just curious are the original DC1 bill of materials the same sizes or did you change any of those. Also do you have a diagram of what needs tapped?

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests