Show us your design ideas and concept images.
-
fernandomaia
- Posts: 8
- Joined: Mon Jul 09, 2018 11:09 am
Post
by fernandomaia » Sat Jul 21, 2018 3:19 pm
Quality bearings such as 6202 have internal metric axle measurement (15mm), however the available bolts close at 15mm are all in inches. The way I found it is to make a axle with an internal thread. After installation insert a pin next to the 8x50mm allen bolt to prevent loosening. Im going to use a C type stop ring to lock the bearing.
This is the concept.

Who is online
Users browsing this forum: No registered users and 0 guests