Page 1 of 1

PLASMA CUTTING???

Posted: Wed Jul 12, 2017 9:11 pm
by axle928
Hello Dan!! Thanks for the great resource!! Is a plasma cutter acceptable to procure the grinder in place of water jet , or laser cutting ? thanks Again!!
Alex

Re: PLASMA CUTTING???

Posted: Wed Jul 12, 2017 9:28 pm
by admin
I have used a "home" plasma cutter and it doesn't have the accuracy required. Perhaps there is some commercial operation that can make a cut to within a few thousandth of an inch and make holes .22" in diameter.

Dan

Re: PLASMA CUTTING???

Posted: Fri Jul 28, 2017 1:37 pm
by dancom
I did a little reading on high resolution plasma cutting and yes, one of those machines would do a fine job.