Hello Dan!! Thanks for the great resource!! Is a plasma cutter acceptable to procure the grinder in place of water jet , or laser cutting ? thanks Again!!
Alex
PLASMA CUTTING???
Re: PLASMA CUTTING???
I have used a "home" plasma cutter and it doesn't have the accuracy required. Perhaps there is some commercial operation that can make a cut to within a few thousandth of an inch and make holes .22" in diameter.
Dan
Dan
Re: PLASMA CUTTING???
I did a little reading on high resolution plasma cutting and yes, one of those machines would do a fine job.
Who is online
Users browsing this forum: No registered users and 1 guest