Discussion on where to source parts and services for your build.
- Posts: 7
- Joined: Wed Jul 12, 2017 8:50 pm
Hello Dan!! Thanks for the great resource!! Is a plasma cutter acceptable to procure the grinder in place of water jet , or laser cutting ? thanks Again!!
- Site Admin
- Posts: 136
- Joined: Wed Jul 05, 2017 8:03 am
I have used a "home" plasma cutter and it doesn't have the accuracy required. Perhaps there is some commercial operation that can make a cut to within a few thousandth of an inch and make holes .22" in diameter.
- Posts: 11
- Joined: Mon Jul 10, 2017 9:24 pm
- Location: Alberta, Canada
I did a little reading on high resolution plasma cutting and yes, one of those machines would do a fine job.
Who is online
Users browsing this forum: No registered users and 1 guest