HI from Australia

[Louw]

Hi I have joined on Dec 24, 2017 But I haven't done any thing about My grinder yet. I have down loaded the metric files that forum member c3ham has put on the forum on Sat Aug 12, 2017 8:14 IEC Motor viewtopic.php?f=11&t=44

download/file.php?id=52

This file is for a IEC motor .I have changed the file to a B14A -''C face" Motor .I will cut the grinder frame out of MDF (wood ) to test the file,or at least my changes on the dwg. file.

I will post my progress .It might take some time ,hope to get it done by Desember for a from me to me Christmas present