IEC Motor

[admin]

Calling all IEC motor guys. We're looking for the best possible option for a C face IEC motor frame. The IEC motors that I have been studying don't lend themselves handily to the design because of the D flange B5 is quite large to get through the left frame piece. However the C flange B14 looks promising. Some of the terminal boxes are choked right up to the shaft end.

Anyone have any suggestions? We can modify the files and make a proper metric IEC version when we get a common motor sorted out.

Thanks,

Dan

[Wild Russian]

Would be this pdf helpful? NEMA/IEC chart
http://ecatalog.weg.net/files/wegnet/WE ... nglish.pdf
Me personally gathered B14A frame 80 (1.1 kW) with 19 mm shaft, but as I know - more popular are motors 1.5 kW with 22 mm shafts

[c3ham]

metric grinder.dwg

(70.53 KiB) Downloaded 1086 times

Hi Dan

Here is the what I have done so far to convert you file to metric I will try and complete it in the next few weeks

p.s this has been modified for a frame 80 1.5kw TEC motor

cheers
Craig

[Belpaese]

Hi Craig where did you buy this motor? Planning g to buy from UK where it is a lot cheaper.
Thanks in advance Belpaese.

[TommyG]

metric grinder.dwgHi Dan

Here is the what I have done so far to convert you file to metric I will try and complete it in the next few weeks

p.s this has been modified for a frame 80 1.5kw TEC motor

cheers
Craig

Hi Craig
Was this the final drawing or are you still working on the rest? Also could I bother you for the pdf version? Any help would be greatly appreciated.
email gloverdynamic@outlook.com