IEC Motor

Suggest ideas for attachments, safety, or overall design improvements.
Post Reply
User avatar
admin
Site Admin
Posts: 126
Joined: Wed Jul 05, 2017 8:03 am

IEC Motor

Post by admin » Thu Jul 27, 2017 3:58 pm

Calling all IEC motor guys. We're looking for the best possible option for a C face IEC motor frame. The IEC motors that I have been studying don't lend themselves handily to the design because of the D flange B5 is quite large to get through the left frame piece. However the C flange B14 looks promising. Some of the terminal boxes are choked right up to the shaft end.

Anyone have any suggestions? We can modify the files and make a proper metric IEC version when we get a common motor sorted out.

Thanks,

Dan

Wild Russian
Posts: 6
Joined: Thu Aug 03, 2017 8:12 am

Re: IEC Motor

Post by Wild Russian » Fri Aug 04, 2017 7:13 am

Would be this pdf helpful? NEMA/IEC chart
http://ecatalog.weg.net/files/wegnet/WE ... nglish.pdf
Me personally gathered B14A frame 80 (1.1 kW) with 19 mm shaft, but as I know - more popular are motors 1.5 kW with 22 mm shafts

c3ham
Posts: 6
Joined: Tue Jul 18, 2017 11:45 am

Re: IEC Motor

Post by c3ham » Fri Aug 11, 2017 4:14 pm

metric grinder.dwg
(70.53 KiB) Downloaded 305 times
Hi Dan

Here is the what I have done so far to convert you file to metric I will try and complete it in the next few weeks

p.s this has been modified for a frame 80 1.5kw TEC motor

cheers
Craig

Belpaese
Posts: 2
Joined: Sun Jul 23, 2017 10:26 pm

Re: IEC Motor

Post by Belpaese » Thu Nov 16, 2017 4:39 am

Hi Craig where did you buy this motor? Planning g to buy from UK where it is a lot cheaper.
Thanks in advance Belpaese.

TommyG
Posts: 5
Joined: Tue Oct 03, 2017 8:32 am

Re: IEC Motor

Post by TommyG » Sat Sep 01, 2018 4:50 am

c3ham wrote:
Fri Aug 11, 2017 4:14 pm
metric grinder.dwgHi Dan

Here is the what I have done so far to convert you file to metric I will try and complete it in the next few weeks

p.s this has been modified for a frame 80 1.5kw TEC motor

cheers
Craig
Hi Craig
Was this the final drawing or are you still working on the rest? Also could I bother you for the pdf version? Any help would be greatly appreciated.
email gloverdynamic@outlook.com

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest